SURFACE PREPARATION
MIXING
• Clean the new surface with the
help of a stiff wire brush.
• In case of growth of algae/
fungus, treat the affected area
with 4% solution of bleaching
powder.
• Fill up the dents and cracks with
cement sand mortar.
• Wash the surface and allow it to
dry partially before application.
• Increase coverage of emulsion
paint if used as a base coat.
PAINT PREPARATION & APPLICATION
• To one volume of fresh water in a
clean container add equal volume of
ECOCEM (1:1) and stir well to get
uniform consistency. No further
dilution is required and ECOCEM is
ready for application.
• Clean the new surface with the help
of a stiff wire brush.
• A fill up the dents and cracks with
cement sand mortar and allow to dry.
• Apply 1st coat of paint.
• After 8-10 hours cure the wall with a
fine spray of water.
• Apply 2nd coat and cure again after
8-10 hours.
• Coverage: 25-35 sq. ft. per kg/coat.
• Packing: 5 kg & 25 kg bags.
• Wash the surface and allow it to dry
partially before the application.
CAUTION
• For best results use soft water
for mixing of paint. Avoid
saline or hard water.
• Consume the paint within 90
minutes of mixing with water
• Mix water in the ratio 1:1 to
form a uniform consistency.
• Washing & proper cleaning is
required before application for
exterior as well as interior
surfaces.
• Saves upto 20% of the cost if
applied as a base coat before
applying emulsion paint.
• Do not use dark shades over
large areas.
Reviews
There are no reviews yet.